Solving the Ground-Truth Bottleneck in Music Source Separation: Announcing mixforge-audio on PyPI A developer released mixforge-audio v0.1.0 on PyPI, an open-source Python engine that builds reproducible test mixes with an exact answer key and calibrated acoustic bleed for evaluating music source separation models. Validated on 20 multi-track songs (40 mixes) from MUSDB18-HQ, the tool reported a 40/40 verification pass rate, a maximum mixture-to-stem residual of 6.52 × 10⁻⁸ in 64-bit float, and a -69.3 dB median residual versus original master mixes, running on NumPy, SciPy and SoundFile without GPU compute. 🚀 Excited to announce the official release of mixforge-audio v0.1.0 on PyPI If you work in Audio AI, Music Source Separation Demucs, Spleeter, Open-Unmix , or Bleed Detection, you've hit this core evaluation bottleneck: 👉 On commercial tracks, the true ground truth is completely unknown. Commercial recordings contain unmeasured mic leakage, mastering compression, and stereo imaging that bias metrics SDR, SIR, SAR . When models fail, it's hard to tell whether separation failed or if source stems had bleed originally. mixforge-audio solves this: an open-source Python engine engineered to build reproducible, mathematically exact test mixes with an unalterable answer key and calibrated acoustic bleed. recipe.json recording every sample offset, gain factor, and clipping ratio. mixforge verify verifies |Mixture - ∑ Stems| ≤ ε and checks that leaky stems match recipe bleed. Validated across 20 multi-track songs 40 mixes from MUSDB18-HQ: ✅ Verification Pass Rate: 40 / 40 mixes OK 0 failures ✅ 64-Bit Float Precision: Max |Mixture - ∑ Stems| = 6.52 × 10⁻⁸ ✅ Flat Bleed Precision: 0.0000 dB gap between requested and measured leakage ✅ Low-Pass Bleed: -14.45 dB high-frequency damping above 4 kHz ✅ Official Mix Residual: -69.3 dB median vs original master mixes well below the human auditory threshold No PyTorch, TensorFlow, or GPU compute needed. Runs purely on NumPy, SciPy, and SoundFile for instant, sub-second execution on any CPU or CI/CD runner. Install directly from PyPI: pip install mixforge-audio Generate a test dataset with bleed in 1 command: mixforge make stems/ --out mixes/ --count 3 --seconds 10 \ --bleed "drums vocals:-26@4000" --bleed "bass other:-30" \ --seed 42 Verify mix integrity: mixforge verify mixes/ --html report.html 🔗 PyPI: https://pypi.org/project/mixforge-audio/ https://pypi.org/project/mixforge-audio/ 💻 GitHub: https://github.com/BoobalanArjunan/Mix-Forge https://github.com/BoobalanArjunan/Mix-Forge If you're benchmarking separation models or training audio bleed detectors, give it a spin ⭐