NVIDIA Jetson + ROS 2 + LiDAR: Building an Autonomous Navigation System A developer published a tutorial on building an autonomous navigation stack for robots using NVIDIA Jetson, ROS 2, and LiDAR, covering how sensor data flows through ROS 2 into localization, mapping, obstacle avoidance, and navigation. The guide emphasizes vendor-neutral ROS 2 interfaces so the architecture adapts to common 2D and 3D sensors, and walks through workspace setup, publisher/subscriber verification, a layered safety architecture, and a Flutter-to-ROS 2 gateway pattern. It stresses measuring before optimizing and keeping AI models and remote UIs from bypassing safety logic. Learn how LiDAR data flows through ROS 2 and into localization, mapping, obstacle avoidance, and navigation. The tutorial emphasizes the ROS 2 interfaces rather than one specific LiDAR vendor, making the architecture adaptable to common 2D and 3D sensors. By the end of this tutorial, you will have: You should have: Version note: NVIDIA Jetson, JetPack, CUDA, TensorRT, Isaac ROS, and ROS 2 compatibility changes over time. Check the current NVIDIA support matrix and the documentation for your exact board before installing packages. Do not blindly mix commands from different JetPack/ROS 2 releases. Start by confirming the device and installed software: uname -a cat /etc/os-release Then update package metadata: sudo apt update Keep the base system consistent with the JetPack release supported by your target robotics stack. Install the ROS 2 distribution supported by your Jetson/Isaac ROS combination. After installation, source ROS 2: source /opt/ros/