# I Let an AI Agent Design My Raspberry Pi CM4 Board — 486 Checks Later, Here's the Scoreboard > Source: > Published: 2026-10-24 16:07:46+00:00 **TL;DR:** For two days, an AI coding agent (Codex) has been designing a Mini-ITX I/O board for the Raspberry Pi CM4 by driving KiCad from the command line in an inspect → fix loop. ERC is clean, the 5V rail passed 486 analysis conditions, routing has started — and the power design is fighting back. This is build log #1. I'm building a carrier board for the Raspberry Pi Compute Module 4. Or, more accurately: I'm *watching* one get built. The designer is an AI agent working through `kicad-cli` and scripted checks — running ERC/DRC, comparing schematic and PCB nets, doing DC analysis on the power rails, fixing what the checks flag, and re-running. My job is reading its inspection reports and looking at renders. It feels less like prompting a chatbot and more like supervising a very fast, very literal junior engineer who never sleeps and documents everything. If you know the CM4, you see the problem immediately: the module exposes **one** PCIe Gen2 x1 lane, and DisplayPort isn't native to it. Cramming this into Mini-ITX, with ATX soft-power handling on top, is exactly the kind of dense, constraint-heavy problem I wanted to throw at the loop. Everything goes through the CLI and scripts, roughly like this: ``` kicad-cli sch erc board.kicad_sch # electrical rule check kicad-cli pcb drc board.kicad_pcb # design rule check # + custom scripts: net consistency, power DC analysis across tolerances ``` No GUI, no mouse. Just checks, fixes, and re-checks — hundreds of iterations. The moment that made me start this log is a clearance check in the power section. On the front copper, a signal trace (D4 TX N) has to pass the *projection* of the back-side MOSFET's drain pad — Q901, sitting next to the R900 current shunt. The drain is a high-current power net, so the loop projects the back-side pad onto the front view and routes the signal around it, checking clearance point by point. Unglamorous, invisible work. Also the work that decides whether a board works at all. The silkscreen on the current layout literally reads "UNROUTED ENGINEERING DRAFT / DO NOT FABRICATE". Accurate. If you've designed CM4 carrier boards: Genuinely collecting answers — the loop and I are still deciding, and I'd rather learn from your scars than earn my own. Part 2 when routing finishes (or when the startup analysis finally completes instead of timing out — whichever comes first).