How to Clean Up Logos and Text Overlays in Your Own Demo Videos

A developer outlined a practical workflow for using AI inpainting to remove logos, timestamps, and text overlays from demo videos, emphasizing frame-by-frame consistency to avoid flicker. The guide recommends testing on a still frame from the busiest section before running a full pass, painting slightly past overlay edges, and avoiding extra re-encodes to preserve resolution. It promotes the browser-based tool Clearframe for the task and notes the workflow applies only to one's own recordings or media with permission to edit.

You just recorded the perfect screen demo for your launch post or README. Then you notice it: a recording-tool logo in the corner, a burned-in timestamp, or an old "draft" label from a previous cut. Your options are usually bad. Re-recording is slow. Cropping changes your framing. Blurring makes viewers wonder what you are hiding. AI inpainting gives you a fourth option: mark the area you want removed and let the tool rebuild those pixels from the surrounding scene. Here is a practical workflow for doing that on video, where cleanup is trickier than on a single screenshot. On a screenshot, the tool fills one region once. In a video, the same region appears across hundreds of frames, and the background behind it may move. The patch has to look plausible in every frame, not just the first, or it will flicker. So with video, preparation matters more: Cut the clip down to the section you will publish. Shorter clips process faster and leave less footage to review. If the overlay only appears for part of the video, isolate that section. Before running the whole clip, test on a still frame from the busiest part of the video. In Clearframe https://www.clear-frames.com/ , you brush over the logo or text stamp and let inpainting fill it in. If the still looks clean, the video pass has a good chance of looking clean too. If it does not, fix the brush before you spend time on the full run. Paint slightly past the edge of the overlay, especially where it has soft shadows or anti-aliased text edges. A tight mask often leaves a faint outline. Watch the result twice: Pay extra attention to moments where the camera pans or something passes behind the removed area, like a cursor or a dropdown opening. Keep the cleaned file at the same resolution as the source. Clearframe is built to preserve resolution, so don't push the output through several other tools. Every extra re-encode adds compression artifacts, and they show up right where the patch is. If you ship product demos regularly, a few habits save a lot of rework: Inpainting works best on: It struggles with: For the hard cases, re-exporting from the original project file is usually the better answer. This workflow is for your own recordings, your company's assets, or media you have permission to edit. Removing another creator's watermark from their work is not a legitimate use. Grab one short demo clip with a leftover logo, test a single frame, then run the full pass. Clearframe https://www.clear-frames.com/ runs in the browser, so there is no desktop editor to install. Try Clearframe: https://www.clear-frames.com/ https://www.clear-frames.com/