Gradio Spaces stuck in NO_APP_FILE despite valid app.py and README.md A Hugging Face Spaces user reported that roughly 10% of Gradio Spaces that fail to start are silent platform-side failures, such as network or repository errors, rather than configuration mistakes. The user advised duplicating the official gradio/hello_world Space with sdk_version set to 5.49.1 on CPU Basic hardware to rule out the platform, noting the official template's README uses app_file: run.py rather than app.py. Adding to the above: I’ve built Spaces thousands of times. Most “won’t start” problems are config mistakes, but in my experience roughly 10% are silent failures on the HF side, such as a network or repository error. When that happens, nothing you change in your repo helps, and you just have to wait. The tricky part is that these platform-side failures look exactly like config errors from the outside. So my approach is to try one quick fix, and if that doesn’t work, rule out the platform first instead of tweaking your repo over and over. The fastest way to rule it out is to duplicate the official gradio/hello world https://huggingface.co/spaces/gradio/hello world Space, change sdk version to 5.49.1 , and keep the same hardware CPU Basic . I just did this myself and it runs fine on 5.49.1: Renecto/hello world https://huggingface.co/spaces/Renecto/hello world . One thing I hadn’t noticed before: the official template’s README uses app file: run.py , not app.py , so make sure app file points to a file that actually exists. Your Space is private, so I can’t see it. That’s about as far as I can help from here.