Density Feedback Control for Transferability of Generative Sparse Adversarial Attacks A new arXiv paper (2611.25001v1) proposes Density Feedback Control (DFC), a method that adjusts a generator-based sparse adversarial attack's sparsity coefficient at the end of each epoch based on the gap between observed hard-mask density and a target, without changing the generator architecture or loss. At a 10% target density, DFC brings the mean density of three base attacks within one percentage point of the target in a single run and improves transfer attack success rate (ASR) for two of them on CNN and Transformer targets, including under per-image ℓ0 budgets, while perturbing fewer pixels. The authors report DFC yields no consistent gain for EGS-TSSA, which restricts perturbations to source-model feature-importance regions. arXiv:2611.25001v1 Announce Type: new Abstract: Generator-based sparse adversarial attacks train encoder--decoder networks to produce transferable sparse perturbations for black-box robustness evaluation. Their perturbation density, however, is set only indirectly by a fixed sparsity coefficient whose mapping to density is unknown and shifts during training, so reaching a target density requires re-tuning; this fixed pressure also yields little transferability gain once density reduction begins. We propose Density Feedback Control DFC , which tightens or relaxes this coefficient at the end of each epoch according to the gap between the observed hard-mask density and the target, without changing the generator architecture or loss. At a 10\% target density, DFC brings the mean density of three base attacks within one percentage point of the target in a single run and improves the transfer attack success rate ASR of two of them on CNN and Transformer targets, including under per-image $\ell 0$ budgets, while perturbing fewer pixels. Tracing GPG's training, we observe that as DFC relaxes the coefficient, the transfer ASR recovers with the density and overtakes the fixed-coefficient baseline with fewer pixels. For EGS-TSSA, which restricts perturbations to source-model feature-importance regions, DFC yields no consistent gain; we analyze how this restriction interacts with density feedback.