Building a Robotic Hand on a Budget Maker Mahdi built an 18-degree-of-freedom 3D-printed robotic hand and forearm for under $300 in parts, using servo motors housed in the forearm that drive joints via thin steel-rope tendons running through PTFE tubes. Each tendon passes through its joint's center of rotation to keep tendon path length constant, and a coiled flat ribbon cable with a printed guide replaces a slip ring for the rotating arm base. The project addresses dexterity, which the source notes remains a stubbornly hard problem because hardware capable of fine motor movement is often expensive. For all the recent advances in robot control enabled by machine learning, there are still a few problems which remain stubbornly difficult: locomotion, for example, or whole-body balance for humanoids. Dexterity, in particular, has emerged as a particularly hard problem, requiring both software and hardware sophistication; hardware capable of useful fine motor movement is often quite expensive. Mahdi ’s been working on that problem, though, with an eighteen-degree-of-freedom robot hand https://www.youtube.com/watch?v=Sk0x-xMNQks that costs less than $300 in parts. Although the hand is the main point of the project, it’s really a full forearm. The skeleton is 3D printed and driven by servo motors; like a human hand, the motors are located mostly in the forearm and use tendons to actuate the joints. Unlike most servo-driven robot hands, it uses thin steel rope instead of synthetic fiber cables, which eliminates the need to tie small knots — the tendon can simply be tensioned and crimped in place. To reduce friction, each tendon runs through a PTFE tube. Wherever a tendon would have to go past a joint, it passes through the joint’s center of rotation, which keeps the length of the tendon’s path from changing as the joint bends. Each finger on the hand can move side-to-side and flex two joints independently. The base of the arm can also rotate on a servo motor, which made powering the servo motors a challenge: the servos draw too much current for small slip-rings, and larger slip-rings were too expensive. Since the arm didn’t need to rotate continuously, though, he instead used a coil of flat ribbon cable which winds in or our as the joint rotates, with a printed cable guide to keep it from kinking; not only is this much cheaper than a slip ring, it’s also more compact. We’ve seen a few https://hackaday.com/2018/10/18/mechatronic-hand-mimics-human-anatomy-to-achieve-dexterity/ robot hands take the same tendon-based approach https://hackaday.com/2026/10/05/building-a-cheap-dexterous-robot-hand/ before, and the more realistic ones https://hackaday.com/2023/03/16/robot-hand-looks-and-acts-like-the-real-thing/ replace the servo motors with artificial muscles https://hackaday.com/2021/10/28/taking-a-stroll-down-uncanny-valley-with-the-artificial-muscle-robotic-arm/ . Some have even 3D-printed tendons and ligaments https://hackaday.com/2023/11/16/robot-hand-has-good-bones/ .