An open-source ESP32-S3 robot brings AI to the desktop LuwuDynamics has released RIG-TARS, an open-source, 3D-printable desktop robot built on an ESP32-S3 microcontroller, as reported by Ananthu Ashok at Open Source For You. The robot's three-segment body walks and turns on voice commands, driven by three SCS009 serial servos over UART and a six-axis QMI8658C inertial measurement unit for motion sensing. Ananthu Ashok writes at Open Source For You about RIG-TARS, a 3D-printable desktop robot from LuwuDynamics built around an ESP32-S3 microcontroller. Its body is split into three segments that walk and turn on voice commands. Three SCS009 serial servos move the segments over UART, and a six-axis QMI8658C IMU, a chip that senses motion and …